Spectralink 8002 Bedienungsanleitung PDF herunterladen (Seite 93)

Troubleshooting

PN: 1725-36034-001_B.doc 93

Message Description Action

No Host IP (Addr)

The handset is configured for “static

IP” (as opposed to “use DHCP”)

and no valid host IP address (the

handset’s IP address) has been

entered.

Enter a valid IP address in the

configuration settings or change to “use

DHCP.”

No IP Address Invalid handset IP address.

Check the IP address of the handset and

reconfigure if required, or change to “use

DHCP”.

No Net Access

Cannot communicate with LAN

devices through the WLAN (such

as PBX).

Verify the AP connectivity to the LAN.

Verify that all the WEP settings in the

handset match those in the APs.

No Net Found

No APs

Handset cannot find any APs

This indicates any of the following:

No radio link.

Verify that the AP is turned on. Verify

WMM is enabled on AP. WMM is

mandatory.

No ESSID: Auto-learn not

supported (or) incorrect ESSID.

Verify the ESSID of the wireless LAN and

enter or Auto learn it again if required.

AP does not support appropriate

data rates.

Check the AP configuration.

Out of range.

Try getting closer to an AP. Check to see

if other handsets are working within the

same range of an AP. If so, check the

ESSID of this handset.

Incorrect Security settings.

Verify that all the Security settings in the

handset match those in the APs.

No Net Found

xxxxxxxxxxxx yy

x…x = AP MAC address.

yy = AP signal strength.

Handset cannot find a suitable AP;

displays MAC and signal strength

of “best” non-suitable AP found.

Check AP and handset network settings

such as ESSID, Security, Reg domain and

Tx power.

Ensure APs are configured correctly.

Try Site Survey mode to determine a more

specific cause.

Enable WMM in the APs.

No PBX Response

The handset has exceeded its

retransmission limit with no ACK

response from proxy server.

Verify that proxy server IP address and

port are properly configured.

No Reg Domain Regulatory Domain not set.

Configure the Regulatory Domain in the

handset.

No SIP DHCP

DHCP is configured but no valid

SIP option 43 was found.

Check DHCP server configuration for

option 43 and reconfigure if required.

No SW Found

A required software component has

not been identified.

Check that the handset license type

(number) has a corresponding entry in the

slnk_cfg.cfg file.

Check that the pd11wsd.bin and

pi110001.bin entries exist in under this

license type in the slnk_cfg.cfg file.

VoIPon www.voipon.co.uk [email protected] Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 99

Kommentare zu diesen Handbüchern

Keine Kommentare