Spectralink 8002 Bedienungsanleitung PDF herunterladen (Seite 83)

PN: 1725-36034-001_B.doc 83

Certifying the Installation

Prior to determining that an installation is complete, test the handsets

following the sequence given in Chapter 6 Testing a Handset and

conduct a

Site Survey mode test according to the directions given in

Chapter 7 Diagnostic Tools.

The installation may need some adjustments. Note any areas where

coverage is conflicting or inadequate. Note any system difficulties and

work with your wireless LAN and/or LAN system administrator to

determine the cause and possible remedy. See Chapter 10

Troubleshooting for clues to possible sources of difficulties. If any

adjustments are made to the system, re-test the device in the same

vicinity to determine if the difficulty is resolved.

The installer should not leave the site before performing installation

verification.

These tests must be performed in typical operating conditions,

especially if heavy loads occur. Testing sequence and procedure is

different for every installation. Generally, you should organize the

test according to area and volume, placing numerous calls to others

who can listen while you perform coverage tests. Note any areas with

excessive static or clarity problems and report it to a Polycom service

engineer.

The coverage test will also require you to put the handset in

Site Survey

mode and walk the entire coverage area to verify all APs.

Conducting a site survey

Conduct a site survey of the installation, by walking the site looking

for interfering 802.11 systems, adequate coverage and channel

assignment, and correct AP configuration.

1. Referring to

Run Site Survey

, put a handset into Site Survey in the

Any/Smry ESSID mode. Walk throughout the site checking for any

expected APs or other ESSIDs.

2. Then, walk the site again, in

MyID/Smry ESSID mode, this time

checking that every location has adequate coverage (there should

VoIPon www.voipon.co.uk [email protected] Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 98 99

Keine Kommentare

Spectralink 8002 Bedienungsanleitung Seite 83